Fellowes WB 150 User Manual download pdf (Page 8)

Maintenance

Strictly speaking, there is no maintenance required for your machine except occasionally wip-

ing it off with a soft cloth dampened with plain water. You can, however, help extend its life

if you empty the waste drawer regularly to prevent cuttings from interfering with the dies. The

window

above the drawer enables you to easily keep an eye on its contents.

Troubleshooting

If you experience a problem with your machine, you may be able to solve it quickly yourself :

•

Stuck bar

- Your machine is most likely jammed. Follow the jam-clearing procedure at the

end of O p e r a t i o n .

•

Partial last hole

- Your sheets are not properly aligned. Adjust the centering of your docu-

ment, as described under O p e r a t i o n .

•

C r o o ked punch hole line

- The document was not put evenly into the punch entry, or cut-

tings have become stuck below the dies. To release cuttings into the waste drawer, slide a

ruler or cardboard into the entry and move it back and forth a few times.

•

Damaged hole edges

- You may be punching too many sheets at one time. Try reducing

the number of sheets per batch.

•

Loose pages

- The wire is probably not fully closed. Put it back into the wire press and lower

the bar farther than before.

•

Difficult to turn pages

- The wire has been flattened by too much pressure. Unfortunately,

you cannot salvage the document in this case. Next time make sure you lower the bar with

gentle, continuous pressure and not beyond your document’s wire size.

If these measures do not solve your problem, please contact us through one of the

many channels listed under Customer Service. For your safety, please do not attempt

to repair your machine.

1 2 3 4 5 6 7 8 9 10

No comments

Fellowes WB 150 User Manual Page 8