Fellowes PS-10Cs User Manual download pdf (Page 2)

PS-77Cs

ENGLISH

Model PS-10Cs

Indicator lights (red)

Paper Jam

Door Open

Overheated

Will shred: Paper, credit cards, staples and small paper clips

Will not shred: Continuous forms, adhesive labels, transparencies, newspaper,

cardboard, large paper clips, laminates or plastic other than noted above

Paper shred size:

Cross-Cut .....................................5/32 inches x 1-1/2 inches (3.9mm x 38mm)

Maximum:

Sheets per pass (Cross-Cut) ............................................................................. 10*

Cards per pass .................................................................................................. 1*

Paper width ................................................................................ 9 inches/229mm

Continuous operation ........................................................................ 8-10 minutes

* 20lb., 8.5 inches x11 inches (75g) paper at 120v, 60 Hz, 4.0Amps; heavier paper,

humidity or other than rated voltage may reduce capacity. Recommended daily usage

rates: 25-50 paper passes; 25 cards.

• Avoid touching exposed blades under Cross-Cut shredder head.

• Use only designated entry for cards.

• The grounded socket-outlet shall be installed near the equipment

and shall be easily accessible.

• Keep away from children and pets. Keep hands away

from paper entry. Always set to off or unplug when not

in use.

• Keep foreign objects – gloves, jewelry, clothing, hair,

etc. – away from shredder openings. If object enters top

opening, switch to Reverse (R) to back out object.

• Never use aerosol, petroleum based or other flammable products

on or near shredder. Do not use canned air on shredder.

• Do not use if damaged or defective. Do not open shredder head.

Do not place near or over heat or water source.

• 10 sheets per pass to avoid jams.

— To Test SafeSense

Technology

IMPORTANT SAFETY INSTRUCTIONS — Read Before Using!

CAPABILITIES

1 5

Breakthrough Safety Technology! SafeSense

stops shredding when hands are too close to the opening.

SET UP

Sensor lights upPress Auto-On ( I )

Control switch

Auto-On (I)

Off (O)

Reverse (R)

SafeSense

(yellow)

Standby (green)

SafeSense

override switch

See safety instructions below

Window

Shredder head

Sheet capacity gauge

Sheet capacity icon

Paper entry

SafeSense

Technology

Disconnect Power Switch

must be in ON position to

operate shredder.

Insert waste bag (Fellowes

#36052) for easy disposal.

A B

PS-10C

Active Not active

Touch test area

Pull-out bin

Disconnect power switch

Card entry

PS-10C

LIMITED WARRANTY Fellowes, Inc. (“Fellowes”) warrants the cutting blades of the machine to

be free from defects in material and workmanship for 5 years from the date of purchase by the

original consumer. Fellowes warrants all other parts of the machine to be free of defects in material

and workmanship for 1 year from the date of purchase by the original consumer. If any part is

found to be defective during the warranty period, your sole and exclusive remedy will be repair or

replacement, at Fellowes’ option and expense, of the defective part.

This warranty does not apply in cases of abuse, mishandling, or unauthorized repair. ANY IMPLIED

WARRANTY, INCLUDING THAT OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE, IS

HEREBY LIMITED IN DURATION TO THE APPROPRIATE WARRANTY PERIOD SET FORTH ABOVE. In

no event shall Fellowes be liable for any consequential or incidental damages attributable to this

product.

This warranty gives you specific legal rights. The duration, terms, and conditions of this warranty

are valid worldwide, except where different limitations, restrictions, or conditions may be required

by local law.

For more details or to obtain service under this warranty, please contact us or your dealer.

Continuous operation:

8-10 minutes maximum

NOTE: Shredder runs briefly

after each pass to clear entry.

Continuous operation beyond

8-10 minutes will trigger

20-minute cool down period.

Paper jam: Set to Off (O) and empty bin. Replace bin, close door and follow any or all of the below procedures.

Gently pull uncut paper

from paper entry. Plug in.

Press and hold

Reverse (R)

Set to Off (O)

and unplug

Press and hold

Reverse (R)

Run regularly in reverse for

one minute

Oil when bin is full, or

immediately, if:

• Capacity decreases

• Motor sounds different, or

Shredder stops running

OPERATION

TROUBLESHOOTING

MAINTENANCE

*Only use a non-aerosol vegetable oil in long nozzle container such as Fellowes 35250

1 5

Indicator lights:

Yellow - SafeSense

active

Yellow flashing - SafeSense

not active

Make sure bin is pushed in

Wait 20 minutes for motor to cool down

Follow oiling procedure below and repeat twice.

ATTENTION: If the SafeSense

light remains on, you must engage the

Override Switch in order to perform steps above. Once the jam is cleared, reset the SafeSense

feature.

(See SafeSense

instructions below.)

WARRANTY

Alternate slowly back and forth

*Apply oil

across entry

Press and hold

Reverse (R)

2-3 seconds

Shred one sheet

Set to Off (O) Press Auto-On (I)

Press Auto-On (I)

Hold card

at edge

Press Auto-On (I)

Feed into card entry

and release

PAPER

CARD

Set to Off (O)

and plug in

Set to Off (O)

and unplug

Feed into paper entry

and release

SafeSense

override switch

Active Not active

Sensor light illuminated–paper

jammed

Check paper amount

SafeSense

paper jam: If the SafeSense

feature activates (SafeSense

light remains on) to cause the user to think the

shredder has jammed when it has not, use the Override Switch to deactivate the SafeSense

feature and clear the

paper. Warning – when switch is in override position, the SafeSense

light will flash and the SafeSense

feature will NOT

function. Once the paper is cleared, reset the SafeSense

feature.

PS-77C

1 2

Comments to this Manuals

No comments

Fellowes PS-10Cs User Manual Page 2

Comments to this Manuals

Related products and manuals for Shredders Fellowes PS-10Cs