Fellowes PowerShred PS-12Cs User Manual Page 3

  • Download
  • Add to my manuals
  • Print
  • Page
    / 8
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 2
3
BASIC PRODUCT MAINTENANCE
All cross-cut shredders require oil for peak performance.
If not oiled, a machine may experience diminished
sheet capacity, intrusive noise when shredding and could
ultimately stop running. To avoid these problems, we
recommend you oil your shredder each time you empty
your waste bin.
OILING SHREDDER
PAPER/CARD
BASIC SHREDDING OPERATION
Continuous operation:
4-5-minute maximum
NOTE: Shredder runs briefly
after each pass to clear entry.
Continuous operation beyond
4-5-minutes will trigger
20-minute cool down period.
PAPER JAM
ADVANCED PRODUCT FEATURES
SAFESENSE
®
TECHNOLOGY OPERATION
Stops shredding immediately when hands touch the paper opening.
SET-UP AND TESTING
TROUBLESHOOTING
A. Overheat Indicator: When the Overheat Indicator is illuminated, the shredder has exceeded its maximum
operating temperature and needs to cool down. This indicator will remain illuminated and the shredder will
not operate for the duration of the recovery time. See Basic Shredding Operation for more information
about the continuous operation and recovery time for this shredder.
B. SafeSense
®
Indicator: If hands are too close to the paper entry, the SafeSense
®
indicator will illuminate
and the shredder will stop shredding.
A
12 3
Press Auto-On (I) Touch test area and
look for the SafeSense
®
indicator to illuminate
SafeSense
®
is active and
working properly
Alternate slowly back and forthSet to Reverse (R) Set to Off (O)
and unplug
Pull uncut paper from
paper entry
Set to Reverse (R)
5
1 32 4 6
*Only use a non-aerosol vegetable oil in long nozzle container such as Fellowes 35250
FOLLOW OILING PROCEDURE BELOW AND REPEAT TWICE
Set to Reverse (R)
2-3 seconds
* Apply oil
across entry
Set to Off (O)
1 2 3
1
Set to Off (O) Press Auto-On ( I )
3
Feed into paper
entry and release
2
Hold card at edge
4 5
Feed into center of
entry and release
Set to Off (O)
6
OR
AB
Page view 2
1 2 3 4 5 6 7 8

Comments to this Manuals

No comments