Fellowes Helios 60 Manual download pdf (Page 6)

Switch the power on (located at the rear side).

The ‘Power-On’ button will be red. To activate the ma-

chine, press the ‘Power-On’ button on the control panel.

The machine will warm-up, the red LED will flash. The

machine will ‘beep’ (3x) and the LED turns green when

the machine is ready to bind.

Prepare the documents by loading the sheets into the

thermal covers. For best results, do not to place too

many or too few sheets into the cover. Use the binding

thickness scale as a guide. The guide is calibrated in

6mm widths. Helios 60 will accept single or multiple

documents up to a combined total thickness of 60mm

(approximately 600 sheets / 80gsm).

The ‘Auto-Sense’ function calculates the optimum bind-

ing cycle based upon the total binding thickness.

Pull open the document clamp (Heat-Shield feature),

insert the documents into the binding channel. Ensure

the binding covers spine touches the heating element.

The selected binding cycle is shown with blue LED. Use

the timer selection buttons to navigate up or down the

scale, if required. The scale has 10 settings. Eg: 6mm

document thickness = setting 1 (up to 60 sheets),

30mm document = setting 5 (up to 300 sheets).

Start the binding cycle by pressing the ‘Select / OK’ but-

ton. The blue LED will start flashing and counting down,

in sequence. When the cycle is complete, the machine

will beep (3x). The blue LED will switch off.

The machine has an integral cooling tray. It can be

extended from the back of the machine and can also be

pulled upwards to accept larger documents.

When the binding cycle is complete, immediately

remove the documents and place in the cooling tray

or on a flat surface to allow the document to cool. The

document can be removed from the machine mid-cycle

if required, take care – the glue may be hot and

melted.

10.

11.

12.

HOW TO BIND

Let our experts help you with a solution.

Customer Service...

www.fellowes.com

Always call Fellowes before contacting your place of purchase,

see the rear cover for contact details.

NEED HELP?

Ensure the machine is on a stable surface. Check there

is enough clear space around the machine to operate

safely.

Select the correct power lead for the appropriate power

supply. Insert the power lead into the power socket

(located at the rear of the machine).

Plug the machine into an easily accessible mains socket.

Switch the mains supply on.

Open and lift the lid by releasing the safety catches on

the front of the lid.

BEFORE BINDING

1 2 3 4 5 6 7 8 9 10 11 ... 75 76

Comments to this Manuals

No comments

Fellowes Helios 60 Manual Page 6

Comments to this Manuals